{"count":1,"message":"Results returned successfully","results":[{"odiNumber":10247780,"manufacturer":"Mazda Motor Corp.","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"09/11/2008","dateComplaintFiled":"11/05/2008","vin":"JM1BJ246731","components":"EXTERIOR LIGHTING","summary":"THE LOW BEAM HALOGEN BULB (HEADLIGHT) ON THE PASSENGER SIDE OF MY MAZDA RECENTLY BURNED OUT.  >  FIRST COMPLAINT--BECAUSE OF A CRAMPED ENGINE COMPARTMENT, THE BULB IS DIFFICULT TO REPLACE.  I HAVE SMALLISH HANDS FOR A MAN.  THERE WAS BARELY ROOM TO ACCESS THE BULB SOCKET (HOLDER) ON THE OUTSIDE CORNER OF THE HEADLIGHT \"POD\".  >  SECOND COMPLAINT--THE BULB HOLDER WAS COMPLEX.  THE BULB PLUGS INTO AN \"INTERNAL\" SOCKET; THIS PAIR SLIDES INTO THE HEADLIGHT \"POD\"; THE PAIR IS THEN HELD IN PLACE BY A WIRE CLIP; EVERYTHING THUS FAR GETS COVERED BY A RUBBER GASKET; AND LASTLY, THERE'S AN \"EXTERNAL\" CONNECTION (PLUG).  >  THIRD COMPLAINT--THE HEADLIGHT \"POD\" IS A INTRINSICALLY LOUSY DESIGN.  EVEN IN BROAD DAYLIGHT, I COULDN'T SEE THE CATCH-POINT FOR THE WIRE CLIP.  >  FOURTH COMPLAINT--THE \"POD\" ITSELF IS FRAIL.  IT'S APPARENTLY PLASTIC.  THE PLASTIC APPARENTLY AGES BADLY.  MY GENTLE ATTEMPT TO REFASTEN THE WIRE CLIP BROKE SOMETHING ON THE BACK OF THE \"POD\"--I DON'T KNOW WHAT.  SO I WAS FORCED TO REPLACE THE \"POD\" ASSEMBLY AT A COST OF OVER $400.  >  NOTE--I'D PREVIOUSLY REPLACED THREE HEADLIGHT BULBS ON THIS CAR; AND THOUGH SUCCESSFUL, I WAS FRUSTRATED WITH THE PROCESS EACH TIME.  >  THERE OUGHTA BE A LAW!  >  AN OWNER SHOULD BE ABLE TO REPLACE ANY SAFETY-RELATED LIGHT BULB ON THE OUTSIDE OF THEIR VEHICLE WITH 1) NO PRIOR EXPERIENCE MECHANICALLY, EG, A TEEN BARBIE-BIMBO; 2) ONLY MODEST HAND DEXTERITY, EG, AN OLD FART WITH ARTHRITIS; 3) NO TOOL MORE COMPLEX THAN A COMMONPLACE SCREWDRIVER; AND 4) WITHOUT AN OWNER'S MANUAL, EG, AN OLDER USED CAR.  >  THE GOAL HERE IS TO EMPOWER AN OWNER TO KEEP THEIR VEHICLE IN SAFEST CONDITION.  I REQUEST THAT THE USDOT ISSUE AND ENFORCE SUITABLE STANDARDS FOR THE MANUFACTURE OF \"FAMILY\" VEHICLES.  >  IT'S TOO '!@#$% LATE TO HELP ME.  I DOUBT WHETHER I'LL EVER BUY ANOTHER MAZDA.","products":[{"type":"Vehicle","productYear":"2003","productMake":"MAZDA","productModel":"PROTEGE","manufacturer":"Mazda Motor Corp."}]}]}