{"count":1,"message":"Results returned successfully","results":[{"odiNumber":10279060,"manufacturer":"General Motors, LLC","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"08/01/2009","dateComplaintFiled":"08/01/2009","vin":"1G1AS58H997","components":"ELECTRICAL SYSTEM","summary":"NO INCIDENT HAS OCCURRED AT THIS POINT, HOWEVER, I SEE THIS AS A POTENTIAL SAFETY HAZARD.  I HAVE A 2009 CHEVY COBALT WITH BATTERY INSTALLED IN THE TRUNK.  THE BATTERY VENT TUBE IS CONNECTED TO THE TOP OF THE BATTERY BY A PLASTIC ELBOW, A PLASTIC VENT TUBE IS CONNECTED TO THE MALE NIPPLE ON THE ELBOW. THE PLASTIC VENT TUBE INSIDE DIAMETER APPEARS TO BE TOO SMALL INSIDE DIAMETER FOR THE MALE NIPPLE.  THE PLASTIC VENT TUBE IS SPLIT WHERE IT ATTACHES TO MY BATTERY WHERE IT IS PUSHED ONTO THE MALE NIPPLE WHICH WILL ALLOW THE VENTED HYDROGEN GAS TO VENT INTO THE TRUNK (WHICH IS PART OF THE PASSENGER COMPARTMENT ONLY SEPARATED BY THE BACK SEAT)  I THINK PRESENTS A POTENTIAL SAFETY HAZARD AND POTENTIAL FIRE RISK. I CAN SEND YOU A PICTURE OF THE SPLIT VENT TUBE IF YOU NEED TO SEE IT.  I ASSUME THAT THIS IS A FACTORY INSTALLATION DEFECT, THIS IS NOT AN IMPROPER REPAIR DEFECT, SO  THIS SITUATION COULD EXIST ON OTHER MODELS USING THIS TYPE OF VENT TUBING. *TR","products":[{"type":"Vehicle","productYear":"2009","productMake":"CHEVROLET","productModel":"COBALT","manufacturer":"General Motors, LLC"}]}]}