{"count":1,"message":"Results returned successfully","results":[{"odiNumber":10297445,"manufacturer":"Honda (American Honda Motor Co.)","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"12/18/2009","dateComplaintFiled":"12/29/2009","vin":"JH4DC548X6S","components":"EXTERIOR LIGHTING","summary":"1.  HAZARDOUS NIGHT DRIVING LOSS OF LOW BEAM HEADLIGHT DUE TO POOR LIGHT SOCKET DESIGN AND CONSTRUCTION.  THIS DEFECT APPEARS TO BE A BURNOUT LIGHT HALOGEN LIGHT BULB.  2.THE BULB BURNS OUT DUE VIBRATION, OR ARCHING CAUSED BY THE LIGHT BULB LOCKING MECHANISM ASSEMBLY FAILURE LEAVING THE BULB LOOSE, AND HELD IN PLACE ONLY BY THE PROTECTIVE RUBBER BOOT.  THE LAMP SOCKET IS HELD IN PLACE BY A HIGH TENSION SPRING LOCKING INTO A SMALL HOOK PROTRUDING FROM APPROXIMATELY 2? DIAMETER THIN SOFT WHITE METAL CAST DISK ATTACHED WITH 2 SMALL SCREWS TO THE HEADLIGHT REFLECTOR.  THIS TOOTH SHAVES OFF BY THE SPRING PRESSURE AS EVIDENCED BY METAL SHAVINGS PRESENT IN BASE OF THE REFLECTOR.  THIS IS NOT AN ISOLATED OCCURRENCE, AND A BRIEF INTERNET SEARCH HAS TURNED UP MANY OF SIMILAR OWNER REPORTS.  LOSS OF LIGHT IS OFTEN PRECEDED BY THE BLINKING HEADLIGHT.   THERE IS A DANGER OF CRASH DUE TO LOSS OF LIGHTS ON AN UNLIT HIGHWAY.  3.THE SOFT METAL LIGHT SOCKET MOUNT SHOULD BE REPLACED BY A STAMPED SHEET METAL PART THAT WOULD NOT CRACK UNDER THE SPRING PRESSURE.  THE CHOICE OF A VERY SOFT AND THIN METAL DIE CAST FOR THIS PART IS AN OBVIOUS ERROR.   THE STAMPED PART SHOULD BE ALSO MUCH LESS EXPENSIVE THEN THE DIE CAST.  THE ONLY FIX SO FAR IS A REPLACEMENT OF THE ENTIRE HEADLIGHT ASSEMBLY WITH 3 LIGHTS AT $619.53 BECAUSE ACURA REFUSES TO MAKE THE REPLACEMENT DIE CAST DISK AVAILABLE AS A REPLACEMENT PART.   ACURA SERVICE STONEWALLS THE WARRANTY REPAIR REQUESTS.  IN MY CASE, THE ORIGINAL DEALER HAS CLAIMED THAT THE LIGHT IS NOT ABLE TO BE FIXED UNDER THE WARRANTY BECAUSE CAR ?HAD AN IMPACT?.  THE ACURA CASE MANAGER HAS ARRANGED OPINION FROM ANOTHER DEALER WHO HAS SAID THERE WAS ?NO IMPACT?, BUT THE USER ?MUST HAVE BROKEN THE RETAINING HOOK DURING THE LIGHT BULB REPLACEMENT?, HENCE NO WARRANTY SERVICE.   THE ISSUE IS THAT THE LIGHT BULB HAS BEEN FOUND LOOSE IN THE SOCKET, MAKING IT IMPOSSIBLE TO BE REPLACED AT NIGHT.   YOU NEED TO REQUIRE THAT ALL LIGHT BULBS MUST BE REPLACEABLE WITHOUT USE OF TOOLS. *TR","products":[{"type":"Vehicle","productYear":"2006","productMake":"ACURA","productModel":"RSX","manufacturer":"Honda (American Honda Motor Co.)"}]}]}