{"count":1,"message":"Results returned successfully","results":[{"odiNumber":10428668,"manufacturer":"UNKNOWN MANUFACTURER","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"10/02/2011","dateComplaintFiled":"10/04/2011","vin":"","components":"CHILD SEAT","summary":"AT A CAR SEAT CHECK, I INSTALLED A BABY TREND FLEXLOC BASE INTO THE MOTHER'S VEHICLE WITHOUT PROBLEMS.  I INSTALLED A 2ND FLEXLOC BASE IN GRANDMA'S VEHICLE.  BOTH BASES HAD THE ADJUSTABLE FOOT ALL THE WAY OUT.  IN GRANDMA'S VEHICLE, CENTER REAR SEAT, WHEN I PUT PRESSURE ON THE SEATBELT, THE PUSH BUTTON FOR THE ADJUSTABLE FOOT WOULD SLIP FROM THE 4TH POSITION INTO THE 3RD POSITION WITH A LOUD BANG.  THEN IT WOULD CONTINUE TO BEND AS IF TO SLIP OUT AND INTO THE 2ND POSITION.  WE ALSO TRIED INSTALLING THE BASE IN AN OUTBOARD POSITION IN THE VEHICLE WITH THE SAME RESULTS.  I USE (APPROXIMATELY) THE SAME FORCE WHEN INSTALLING ALL BASES OR CAR SEATS AND HAVE NOT HAD THIS PROBLEM IN THE PAST.  MODEL NUMBER FOR THE DEFECTIVE BASE WAS CB63100, DATE OF MANUFACTURE 6/1/11.  THE ONE IN THE MOTHER'S CAR (NOT DEFECTIVE) WAS TS25400, 3/10/11.  VEHICLE WAS AN INFINITI 2002 WITHOUT LATCH (MADE OCT 2001).  I RECOMMENDED NOT USING THE BASE UNTIL IT IS REPLACED.  BASE WAS PLACED IN THE TRUNK OF GRANDMA'S CAR. *TR","products":[{"type":"Vehicle","productYear":"9999","productMake":"UNKNOWN","productModel":"UNKNOWN","manufacturer":"UNKNOWN MANUFACTURER"},{"type":"Child Seat","productYear":"9999","productMake":"BABY TREND","productModel":"FLEX-LOC","manufacturer":"Baby Trend, Inc."}]}]}