{"count":1,"message":"Results returned successfully","results":[{"odiNumber":10936253,"manufacturer":"General Motors, LLC","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"01/01/2013","dateComplaintFiled":"12/19/2016","vin":"1G1YY26U465","components":"EXTERIOR LIGHTING","summary":"THE HEADLIGHT COVERS ARE CRAZING OVER WHICH IS MATERIALLY REDUCING THE LIGHT OUTPUT.    1. THE COVERS CANNOT BE POLISHED.  NOT ONLY DOES THAT DESTROY THE OUTER COATING, THE CRAZING IS THROUGH-AND-THROUGH.  2. THE COVERS ARE GLUED ON AND CANNOT BE REPLACED BY ANY OFFICIAL MEANS, ALTHOUGH SOME INVENTIVE PEOPLE HAVE MANAGED TO SUCCEED (USUALLY AFTER MULTIPLE FAILED ATTEMPTS) BY STICKING THE ENTIRE ASSEMBLY IN THEIR KITCHEN OVEN.  HOWEVER, [SEE NEXT POINT]  3. THE COVERS THEMSELVES ARE NOT AVAILABLE FOR SALE.  4. THE HEADLIGHT ASSEMBLIES THEMSELVES, WHICH COST AROUND $1,000 PER SIDE, ARE SPECIFIC TO THE COLOR OF THE CAR, AND ARE NOW DISCONTINUED.    IN OTHER WORDS, THERE IS NO LEGIT PATHWAY TO FIXING THIS PROBLEM.  GM MADE A THROWAWAY HEADLAMP ASSEMBLY THAT COST A FORTUNE TO REPLACE WHEN IT WAS PRODUCED, AND NOW IT'S NOT AVAILABLE AT ALL.    THIS IS NOT AN OLD CAR.  THESE CARS WERE PRODUCED UNTIL 2013.  THREE AND A HALF YEARS LATER, YOU CAN'T GET ESSENTIAL PARTS TO MAKE THE HEADLIGHTS SAFE.  THOUSANDS OF C6 HEADLAMP COVERS ARE STARTING TO FAIL NOW.    THE NHTSA DID A RECALL FOR THE LOW-BEAM WIRING MALFUNCTION ON THIS CAR.  THIS IS A SIMILAR PROBLEM IN ITS EFFECT.","products":[{"type":"Vehicle","productYear":"2006","productMake":"CHEVROLET","productModel":"CORVETTE","manufacturer":"General Motors, LLC"}]}]}