{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11055540,"manufacturer":"Chrysler (FCA US, LLC)","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"11/08/2017","dateComplaintFiled":"12/19/2017","vin":"2C3LA63HX6H","components":"POWER TRAIN","summary":"PROBLEM: MOMENTARY LOSS OF POWER, CHECK ENGINE AND ETC LIGHTS FLASH. SOMETIMES STALLS COMPLETELY (WHEN VERY SLOW OR STOPPED). IT HAS STOPPED ON ME A COUPLE OF TIMES WHILE TURNING. TO STALL WHILE TURNING ACROSS TRAFFIC IS UNSAFE.    PARTS REPLACED SO FAR:   GAS TANK (RECALL)  GAS PUMP  ACCELERATOR PEDAL    DIAGNOSIS: APPARENT INTERMITTENT CONNECTION AT THE PCM. LAST REPAIR ATTEMPT(11/29/17) THE TECHNICIAN REPAIRED THE CONNECTION BY ALIGNING THE PINS (APPARENTLY SOME HAD PUSHED THROUGH THE BOARD) & CLEANING THE CONNECTION. IT HAS WORKED FINE FOR ABOUT 2 WEEKS SINCE THEN, BUT IS FAILING AGAIN.  THE TECHNICIAN NOW SAYS THERE IS A PROBLEM WITH THE PCM (POWERTRAIN CONTROL MODULE), POSSIBLY DUE TO BROKEN SOLDER JOINTS ON THE BOARD THAT CANNOT BE REPAIRED.  THERE ARE CURRENTLY NO PCMS AVAILABLE FROM DEALERS AND THERE ARE 67 UNITS ON BACKORDER IN THE PAST FEW WEEKS . . . MANY WITH SIMILAR FAILURE MODES.    FROM THE REPAIR SHOP:  \"DIAGNOSED AND TRACED MULTIPLE FAULTS TO COMMUNICATION LOSS AT POWER TRAIN   CONTROL MODULE.   REMOVED UNIT FROM HOLDER AND WHILE ENGINE IS RUNNING IF THE UNIT IT TAPPED   OR SHAKEN THE ENGINE WILL STUMBLE OR STALL.   - CONTACTED COMPUTER REPAIR SHOP AND THIS   IS VERY COMMON ISSUE FOR SEVERAL CHRYSLER IN LAST MONTH OR SO . THE MAIN   PROCESSOR GETS LOOSE ON CIRCUIT BOARD BUT THE CONTACTS ARE SO TINY REPAIR IS   NOT POSSIBLE. NO LOCAL DEALERS HAVE UNIT AND THERE ARE   67 ON BACK ORDER IN LAST WEEKS.\"","products":[{"type":"Vehicle","productYear":"2006","productMake":"CHRYSLER","productModel":"300C","manufacturer":"Chrysler (FCA US, LLC)"}]}]}