{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11210399,"manufacturer":"Ford Motor Company","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"05/17/2019","dateComplaintFiled":"05/28/2019","vin":"3FADP0L38AR","components":"SERVICE BRAKES","summary":"BRAKE FAILURE: I WAS DRIVING MY USUAL COMMUTE AT 70 MPH ON AN INTERSTATE HIGHWAY.  AS I APPROACHED MY EXIT RAMP, I LOOKED DOWN AT MY DASH CONSOLE TO SEE A RED BRAKE WARNING (!).  THERE WERE NO CARS CLOSE, SO I TAPPED MY BRAKES TO MAKE SURE THEY WERE STILL WORKING.  THAT IS WHEN I DISCOVERED THAT THE BRAKES WERE NOT WORKING AT ALL, DESPITE THE PEDAL GOING UP AND DOWN NORMALLY.  NO BRAKES GOING 70!  I WAS ABLE TO GENTLY APPLY THE E-BRAKE UP THE EXIT RAMP AND COME TO A STOP AT THE INTERSECTION.  AT THAT POINT I WAS ABLE TO DRIVE SLOWLY OFF THE ROAD WITH MY E-BRAKE TO MAKE IT TO SAFETY.  THIS COULD'VE ENDED UP SO MUCH WORSE IF THERE HAD BEEN TRAFFIC OR PEOPLE AROUND.  THE REPAIR SHOP THAT FIXED THE CAR REPLACED MY ENTIRE BRAKE PEDAL ASSEMBLY AS SHOWN IN THE ATTACHED IMAGE.  THE SHOP SAYS THAT THE PEDAL WAS NOT PUTTING OUT ENOUGH OHMS (~4.2), WHEN IT SHOULD HAVE BEEN PUTTING OUT BETWEEN 18-20 OHMS.  I HAVE SAVED THE BRAKE PEDAL ASSEMBLY FOR THOSE WHO WOULD LIKE TO INVESTIGATE IT FURTHER.  FORD HAS NOT SHOWN MUCH INTEREST IN MY SITUATION.","products":[{"type":"Vehicle","productYear":"2010","productMake":"FORD","productModel":"FUSION HYBRID","manufacturer":"Ford Motor Company"}]}]}