{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11228639,"manufacturer":"Ford Motor Company","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"04/16/2019","dateComplaintFiled":"07/01/2019","vin":"1FADP3K26EL","components":"ELECTRICAL SYSTEM","summary":"UPON \"CHECK ENGINE\" LIGHT ILLUMINATION, I TOOK CAR TO GARAGE TO HAVE CODES READ. THEY SHOWED ME WHAT THEY BELIEVED TO BE THE ISSUE AND SAID I SHOULD CHECK WITH FORD FOR RECALLS OR COMPENSATION TO HAVE WHAT IS CLEARLY A MANUFACTURING DEFECT FIXED. I GOOGLED MY SITUATION AND WAS STUNNED TO SEE HOW COMMON A PROBLEM IT IS. ONE EXAMPLE OF THIS CAN BE FOUND AT:  HTTPS://WWW.FOCUSFANATICS.COM/FORUM/MK3-FOCUS/517737-TSB-14-0215-CHAFING-WIRING-HARNESS.HTML.  IN MY SITUATION THE WIRE HARNESS HAS CUT THROUGH FROM RUBBING ON THE MANIFOLD AND THERE IS OBVIOUS CORROSION TO THE WIRING. THIS CAUSES SPORADIC LOSS OF ACCELERATION AND HAS CAUSED THE ENGINE TO NOT START UPON TWO OCCASIONS. LOSS OF ACCELERATION WHEN TRAVELING CAN BE EXTREMELY DANGEROUS AND ACCIDENT CAUSING. AND THE COST TO FIX THIS MANUFACTURING FLAW SEEMS DEPENDENT ON HOW MANY WIRES ARE INVOLVED, AND IF ANY CIRCUITS WERE ACTUALLY FRIED AND NON-WORKING AS A RESULT OF THE WIRING ISSUE. I WAS QUOTED UPWARDS OF $1000 FOR THE FULL WIRING HARNESS ALONE WITH NO LABOR (WORSE CASE SCENARIO).  I AM ALSO UNABLE TO PASS NYS INSPECTION UNTIL THE ISSUE IS FIXED AND THE CODES ARE CLEARED. I HAVE SPOKEN TO A REPRESENTATIVE FROM FORD AND WAS INFORMED THAT NO PROGRAMS ARE IN PLACE AT THIS TIME TO DEAL WITH THIS ISSUE. FORD HAS OBVIOUSLY BEEN AWARE OF THIS FLAW FOR SEVERAL YEARS NOW. IF I HAD BEEN MADE AWARE OF THIS ISSUE, IT COULD HAVE BEEN EASILY CORRECTED BEFORE IT BECAME DESTRUCTIVE AND DANGEROUS AND A MAJOR REPAIR JOB. I FEEL IGNORING THIS ISSUE IS NEGLIGENT ON THE PART OF FORD.","products":[{"type":"Vehicle","productYear":"2014","productMake":"FORD","productModel":"FOCUS","manufacturer":"Ford Motor Company"}]}]}