{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11242577,"manufacturer":"UNKNOWN MANUFACTURER","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"06/09/2013","dateComplaintFiled":"08/07/2019","vin":"","components":"EQUIPMENT","summary":"I OWN A SEARS/CRAFTSMAN MOTORCYCLE JACK THAT IS APPROXIMATELY 2 YEARS OLD. (MODEL #50190 SERIAL#KLM10008592). ON 6/9/2013 I HAD JUST FINISHED PERFORMING ROUTINE MAINTENENCE ON MY MOTORCYCLE USING THE JACK. AFTER FINISHING I NOTICED THAT THE RIGHT SIDE LOCKING SCREW ON THE REAR PART OF THE FRAME WAS BENT FORWARD. UPON CLOSER INSPECTION, I NOTICED THAT THERE WAS A MISSING WELD AROUND THE COLLAR OF THE LOCKING SCREW. (THERE ARE TWO SEPARATE WELDS ON THE LEFT SIDE LOCKING SCREW). I DO HAVE PICTURES FOR CLARIFICATION. MY CONCERN IS THAT THE MISSING WELD WAS CAUSING EXCESSIVE STRESS ON THE REMAINING, PARTIAL WELD WHICH WAS STARTING TO FAIL. I BELIEVE THAT IF THE WELD HAD FAILED COMPLETELY, THE WEIGHT OF THE MOTORCYCLE (850 LBS) MAY HAVE SHIFTED ON THE ELEVATED JACK POSSIBLY FALLING, WHICH COULD HAVE CAUSED SERIOUS PHYSICAL INJURY OR EVEN HAVE BEEN FATAL.  I UNDERSTAND THAT THIS MAY BE AN ISOLATED INCIDENT IN REGARDS TO THE MANUFACTURE OF THE JACK BUT I FELT COMPELLED TO NOTIFY SEARS IN THE EVENT THAT OTHER JACKS MAY HAVE BEEN PURCHASED WITH A  MISSING WELD. I HAVE BEEN IN CONTACT WITH SEARS CUSTOMER SERVICE CENTER BUT AT THIS POINT THEY KEEP SENDING ME INFORMATION ON THEIR PRODUCT WARRANTY.  *JS","products":[{"type":"Vehicle","productYear":"9999","productMake":"UNKNOWN","productModel":"UNKNOWN","manufacturer":"UNKNOWN MANUFACTURER"}]}]}