{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11323085,"manufacturer":"General Motors, LLC","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"05/03/2020","dateComplaintFiled":"05/03/2020","vin":"3GCUKREC1GG","components":"SERVICE BRAKES","summary":"WHEN STOPPING VEHICLE THE BREAK PEDAL HAS BEEN VIBRATING AND GOING TO THE FLOOR FOR A FEW DAYS. THIS USUALLY RESOLVES AFTER A FEW MINUTES. HOWEVER TODAY THE BREAK PEDAL VIBRATED AND WENT TO THE FLOOR AND HAS NOT COME BACK UP. THIS IS NOT ALLOWING THE TRUCK TO STOP IN REVERSE OR FORWARD MOTION. WHEN PUT IN REVERSE AND THEN PRESSURE APPLIED TO BREAK THE PEDAL APPEARS TO STAY ON THE FLOOR OF TRUCK. WHEN PLACED IN DRIVE THE PEDAL WILL HAVE SOME PRESSURE BEHIND IT BUT THEN WILL ABRUPTLY GO TO FLOOR AND NOT ALLOW TRUCK TO STOP. THIS OCCURRED BEFORE THE LAST BREAK RECALL ON THIS TRUCK. RECALL WAS COMPLETED AND THEN A FEW MONTHS LATER THE SAME ISSUE HAS OCCURRED. THERE IS ADEQUATE BREAK FLUID IN RESERVOIR AND DOES NOT APPEAR TO BE LEAKING. BREAK PADS ARE IN GOOD CONDITION. THIS SEEMS TO BE EITHER AN INTERNAL COMPUTER ISSUE OR AND ISSUE WITH THE BREAK PEDAL ITSELF. THIS HAPPENED WHILE PULLING INTO A PARKING SPOT AT A SLOW RATE OF SPEED.","products":[{"type":"Vehicle","productYear":"2016","productMake":"CHEVROLET","productModel":"SILVERADO 1500","manufacturer":"General Motors, LLC"}]}]}