{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11425995,"manufacturer":"Subaru of America, Inc.","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"07/21/2021","dateComplaintFiled":"07/22/2021","vin":"4S4BP63C496","components":"SERVICE BRAKES","summary":"While coming down a hill, I applied the brakes, and suddenly lost all brake pedal pressure, only being able to stop using a handbrake. This complete loss of the braking system put me and other drivers at risk. Had I been traveling at higher speeds, an accident could have occurred.   The brake system warning light came on at the same time as I pumped the brake pedal, and there were no prior indications that the brake system was about to fail.   When I inspected the car for fluid leaks, I found that the brake master cylinder was empty and a lot of fluid had collected just in front of the rear passenger-side wheel. The brake line union block at the rear of the car was severely corroded as were the brake lines into and out of the union block.   This exact problem was supposedly addressed by NHTSA recall 14V-311 (Subaru Recall WQK-47). The fix involved either applying an anti-corrosion coating or replacing the faulty brake lines. The recall was marked as completed in 2014. However, the completed recall did not prevent the problem from recurring. Since the recall was marked as \"completed\", Subaru has refused to conduct necessary repairs on the vehicle.   This is a known failure point and serious safety concern in many Subaru vehicles, acknowledged by both NHTSA and Subaru. I claim that the fix completed under the recall was insufficient in preventing brake line corrosion and failure.","products":[{"type":"Vehicle","productYear":"2009","productMake":"SUBARU","productModel":"OUTBACK","manufacturer":"Subaru of America, Inc."}]}]}