{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11431114,"manufacturer":"Ford Motor Company","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"08/28/2021","dateComplaintFiled":"08/30/2021","vin":"1FA6P8CF3F5","components":"UNKNOWN OR OTHER","summary":"I was driving on Interstate-95 in Washington, DC going about 55 mph in heavy traffic.  Without warning my car lost acceleration and the car almost immediately slowed to approximately 35 mph, despite my foot still being on the accelerator--pushing on the accelerator did nothing.  Then after several seconds, the car sped up again, but when I reached around 40 mph, the car lost acceleration again for several seconds.  It kept doing this over the course of my entire trip, which was about 5 miles.  I had to pull in the shoulder lane driving with my hazards flashing.  After I parked my car and turned it off, I noticed my brake lights were still on.  I googled the issue, and the source of the problem is a faulty transluscent plastic/rubber brake switch stop pad (that is connected to the brake pedal and when the brake is released the brake switch stop pad pushes in the brakeswitch turning off the brake lights), which broke during my trip.  I found the broken pieces on my floorboard (i took a photo of them and kept them). Because the car senses that the brakes are still being applied it cuts power to the accelerator.  This was highly dangerous on the interstate and it broke with no warning.  Fortunately, it didn't cause an accident.  While reviewing the fix (Ford doesn't sell the replacement part; instead they want you to replace the entire brake pedal for about $500) on a Mustang Owner Forum, numerous people echoed the same problem with many having it occur while driving.  The fix involves buying a $5-10 part from Dorman which is made for another vehicle.","products":[{"type":"Vehicle","productYear":"2015","productMake":"FORD","productModel":"MUSTANG","manufacturer":"Ford Motor Company"}]}]}