{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11486191,"manufacturer":"Chrysler (FCA US, LLC)","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"09/23/2022","dateComplaintFiled":"09/24/2022","vin":"2c4rc1bg5gr","components":"POWER TRAIN,ENGINE","summary":"Cylinder 3 missfire Loss of hydraulic pump prime. Line pressure low. LC pressure switch rationality. Yes it's available for inspection. Unknown if reproduced by dealer or other Unknown if inspected by manufacturer or other.  The check engine light came on a little after 90k miles, at which time it was out of warranty, the mechanic said it had a weak cylinder and the motor needed to be replaced or rebuilt, but it was still drivable. The van would start shaking and loses power under moderate acceleration (like getting on interstate) and begin dinging but eventually gain power back. Around 119k miles, the van made a loud Squealing sound and started loosing speed very quickly in the middle of traffic. I put the car in park and back in drive to see if I could get it out of the road.  It then started to roll backwards I barely pushed the gas and it revved up to 6000 RPM and then jerked and quickly accelerated forward. If a car would have been close enough I would have hit them while rolling backwards and when it accelerated forward. Upon inspection, the faults listed above came up. The van is no longer drivable but still starts.","products":[{"type":"Vehicle","productYear":"2016","productMake":"CHRYSLER","productModel":"TOWN AND COUNTRY","manufacturer":"Chrysler (FCA US, LLC)"}]}]}