{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11515412,"manufacturer":"Honda (American Honda Motor Co.)","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"01/01/2016","dateComplaintFiled":"04/04/2023","vin":"1HGFA16857L","components":"SEAT BELTS","summary":"UNKNOWN. This has been an ongoing problem for years. I finally retired and had enough time to trace it down  Water was getting on the floor of my car on passenger side after substantial rainfall. Extended shoulder harness webbing as far as it would go and found webbing soaking wet from water on last 2 feet of webbing that could be exposed and assume webbing still wet hidden within sidewall panel.  (Nobody used the shoulder harness on passenger side of car) Taped off sunroof and doors on that side and found when using a water hose, water was getting into the passenger shoulder harness area and also dripping out of shoulder harness sidewall height adjuster. Removed the roof moulding trim strip on right side of roof, inspected, found no body seam sealant had been applied at the factory in the area where roof and side panel of car was spot welded when manufactured. Welds are still ok but an exposed gap was missing  body seam-sealant along the area starting about 18 inches aft of windshield.  I purchased seam sealant at body shop and applied seam sealant myself. Rechecked for leakage after sealant cure. Was ok. Re-installed roof moulding trim strip. Not sure if any water damage has occurred to shoulder harness mechanism. No apparent binding of mechanism at this time.","products":[{"type":"Vehicle","productYear":"2007","productMake":"HONDA","productModel":"CIVIC","manufacturer":"Honda (American Honda Motor Co.)"}]}]}