{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11516089,"manufacturer":"Hyundai Motor America","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"04/01/2023","dateComplaintFiled":"04/08/2023","vin":"5NMS44ALXMH","components":"UNKNOWN OR OTHER","summary":"After jacking up the car to do a tire swap from winter tires and wheels to the OEM tires and wheels on the front passenger side using the factory supplied scissors jack the vehicle rocked slightly, causing the jack to fall over and the vehicle to drop. I had already completed the tire and wheel swap on the driver side of the vehicle without incident. At this point the lug nuts were loose but had not yet been removed, so no damage to the vehicle occurred. This event happened in my garage that has a flat concrete floor with an epoxy coating. I was not touching the vehicle at the time. The vehicle was in park but the electronic parking brake was not manually set (not sure if that can be done).  I believe the transmission (8 speed DCT) allows too much movement fore and aft before engaging the parking pawl that locks the front axles and prevents movement. Also, due to the height of the vehicle, the scissors jack must be extended near the very top of the maximum lifting height to raise the tires about 1/2\" above the ground level, where the jack is naturally the least stable.  I used wheel chocks on the opposite diagonal corner for the remaining wheels.  The jack sustained a bent threaded shaft but otherwise appeared to be ok and the support arms did not seem to be bent. I will be replacing this jack with a sturdier unit soon and will not use this one again, however I will keep it in case in its needed for examination.","products":[{"type":"Vehicle","productYear":"2021","productMake":"HYUNDAI","productModel":"SANTA FE","manufacturer":"Hyundai Motor America"}]}]}