{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11527384,"manufacturer":"Toyota Motor Corporation","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"05/26/2023","dateComplaintFiled":"06/16/2023","vin":"5TDGZRAH0NS","components":"STRUCTURE","summary":"The lower front clip/air dam came off the vehicle at highway speeds(75mph) on a 2 lane highway. Highway 180 in west Texas east of Seminole, TX. A flat front face semi-truck(75mph I am guessing, but it is known the trucks exceed that speed regularly in that area.) traveling in the opposite direction. I was completing the merge to the left as a passing lane section of the highway was ending. As we passed, just a double yellow strip separating the vehicles,  the wind force from the truck caused the front left(drivers side) part of the air damn to detach. The air dam was pulled under the vehicle and the entire part was ripped off the highlander and pulled under. Running over the part caused me to almost lose control of the vehicle. Luckily there was no one directly behind me or it could have been worse. If the part had been caught up in the drive train, I would have lost complete control at the 75mph speed. The dealer is denying my story and said I must of hit something.  There are zero front impact marks on the air dam or any other part of my vehicle. The weather conditions were clear. About 3:30PM on a Friday. The highway was newly paved so there were no potholes or other road conditions. The front left part of the air dam is held in place by 2 plastic push pins.  My theory is the wind force between the 2 vehicles passing at 75-80 mph was sufficient to cause the air dam to to be deflected enough to hit the highway. I do not know the physics of the air forces, but I am guessing it was a combined 130 mph wind gust that was generated.","products":[{"type":"Vehicle","productYear":"2022","productMake":"TOYOTA","productModel":"HIGHLANDER","manufacturer":"Toyota Motor Corporation"}]}]}