{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11548306,"manufacturer":"General Motors, LLC","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"09/25/2023","dateComplaintFiled":"10/04/2023","vin":"1GT49PE75RF","components":"UNKNOWN OR OTHER","summary":"Upon starting our 2024 GMC Sierra 2500HD after towing a camping trailer for approximately 200 miles, the following error notifications would cycle every 20 seconds to 5 minutes:      \"Check Trailer Wiring\"      \"Service Trailer Brake System\" The trailer brake would become disabled after these errors, and sometimes would connect with a \"trailer brake connected\" message, only to repeat every 20 seconds to a few minutes later.  During the 60 minutes in which I drove to an RV dealership to have the problem looked at, on multiple occasions, I had no trailer brakes when braking, or had no trailer brakes until the trailer brakes suddenly connected at below the speed of 35 - 25 MPH. GM has acknowledged document ID: 6420021 and bulletin #23-NA-149 that this could happen when pulling a trailer with a battery, generator, or solar charger that has a higher state of charge than the vehicle battery. This is an extremely unsafe condition that could easily cause a rear-end accident or a jackknife condition of the vehicle/trailer combination.   GM has known about this issue since at least June of 2023, and as of September, they have an updated trailer brake controller that is supposed to correct this issue.  There should be an immediate recall of the vehicles involved to have the trailer brake module replaced with the updated part.","products":[{"type":"Vehicle","productYear":"2024","productMake":"GMC","productModel":"SIERRA 2500","manufacturer":"General Motors, LLC"}]}]}