{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11555268,"manufacturer":"Mitsubishi Motors North America, Inc.","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"04/09/2022","dateComplaintFiled":"11/15/2023","vin":"4A4AP3AU8DE","components":"ELECTRICAL SYSTEM","summary":"My electrical system and/or computer brain is not operating properly. About a year and 1/2 ago the low beam passenger light stopped working. I had the bulb replaced at Walmart. 2 months later it went out again. Walmart checked and said the bulb was not the problem so I went to Firestone and was told the wiring was melted. Firestone said my options were to replace the entire harness or pig tail the low beam. I opted for the pig tail. A few months later I had issues with slow starts as if my battery was being drained. A few weeks after that my drivers side low beam started working intermittently.  Then went out completely. I went to Gillman dealership in Schertz, TX (330 miles from my home) who said the bulb needed to be replaced which they did. A month later the drivers low beam is out again. Firestone says the wiring has melted on that side too. This time I asked them not to fix it because I wanted to go back to the dealership to repair.  1 week later my battery died twice and the passenger low beam has stopped working again.  A mechanic advised that a few years ago he worked on a 2012 Mitsubishi with the same issues and ended up totaling it out because the car\u2019s computer was not modulating voltage properly. He said that car\u2019s computer was not reading the codes correctly and was outputting voltages that did not match the Outlanders configuration. I was told there is a recall for this already. I wanted information on this before contacting the Texas State Attorney General\u2019s Consumer Protection Office.","products":[{"type":"Vehicle","productYear":"2013","productMake":"MITSUBISHI","productModel":"OUTLANDER SPORT","manufacturer":"Mitsubishi Motors North America, Inc."}]}]}