{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11623102,"manufacturer":"Chrysler (FCA US, LLC)","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"10/24/2024","dateComplaintFiled":"11/01/2024","vin":"3C4PDCAB9GT","components":"POWER TRAIN,UNKNOWN OR OTHER,ENGINE","summary":"While driving the car, car stalled and began displaying the lightning bolt icon on the cluster. The power steering stopped working and the brake was very stiff and hard to depress. I pulled off the road and waited a few minutes and started the car again. The idle was very rough, icon was still displayed on the cluster, and car began jerking and stalled again. I had the vehicle towed to the house and began looking into the issue. Error codes read on the car was P0365: Camshaft Position Sensor \u201cB\u201d Circuit, and the red lightning bolt indicating an issue with the electronic throttle body. The battery was taken out and tested bad so it was replaced. The throttle body was cleaned and tested good. When I tried to start the car after the codes were cleared, the vehicle attempted to start but wasn't able to turn over fully. The P0365 code returned. I then had a mechanic come check out the car to see if he could do anything to help. He determined that the valves in the engine were bent and the cars timing was off.  With all of this being said, This issue I am complaining about is the P0365 Camshaft sensor code. There was a recall for the camshaft sensors in some 2016 Dodge Journeys but my VIN did not fall in that range. When I called FCA, I was told there was nothing to be done because my VIN wasn't included in the recall.   A bad camshaft sensor would cause all of the issues that I am experiencing with the car. If the sensor is bad or doesn't perform as it should, it could effect the overall timing of the engine's firing sequence, causing stalling, failure to start, and damage to the engine, like in my case with the bent valves.  This incident posed a severe safety risk to myself and the other drivers around me due to the loss of power steering and partial loss of braking ability. Luckily this incident did not occur on the interstate or major highway, where there are speeds in excess of 55 mph.","products":[{"type":"Vehicle","productYear":"2016","productMake":"DODGE","productModel":"JOURNEY","manufacturer":"Chrysler (FCA US, LLC)"}]}]}