{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11698141,"manufacturer":"Ford Motor Company","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"10/09/2025","dateComplaintFiled":"11/07/2025","vin":"1FMDE5BHXML","components":"ELECTRICAL SYSTEM,VEHICLE SPEED CONTROL","summary":"I was driving on the highway at a speed of approximately 70 miles per hour when the Bronco driver screen gave multiple warning notices and at the same time, the accelerator would not react.  Steering power was fine.  I was in the second from far left lane on a six lane highway and losing speed quickly.  I was able to move to the right and drift to the side of the road without incident.  Once stopped, I turned the ignition off and waited a few seconds and then turned it back on again.  The error messages all cleared and the Bronco accelerator reacted appropriately.  I drove it straight to the dealership for inspection.  They found the 210 connector was not making a good connection.  They cleaned it and added electric grease and reconnected.  Everything cleared and the connection was deemed good.  I have not worked in the Bronco engine compartment or had work done that would have resulted in loosening the 210 connector.  My understanding from the shop is that corrosion caused this connector to loosen.","products":[{"type":"Vehicle","productYear":"2021","productMake":"FORD","productModel":"BRONCO","manufacturer":"Ford Motor Company"}]}]}