{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11711521,"manufacturer":"Ford Motor Company","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"10/20/2025","dateComplaintFiled":"01/16/2026","vin":"1FATP8UH5H5","components":"BACK OVER PREVENTION","summary":"The contact owns a 2017 Ford Mustang. The contact stated that there were intermittent failures with the rear-view camera image. The contact had opened the trunk and noticed that the mesh covering the electrical wires was deteriorating. There was tape holding the mesh to the wires. The tape was rewrapped, and the camera became functional. The contact received notification of NHTSA Campaign Number: 25V572000 (Back Over Prevention). The contact stated that approximately one month after receiving the recall notification, the rear-view camera failed again. The vehicle was taken to a local dealer, who advised the contact that the camera was inspected, and no failure was found. The vehicle was retrieved, but the camera image was distorted, and eventually, there was no image displayed. There was a message that the camera needed to be serviced. The vehicle was returned to the same dealer, who determined that the failure was not due to the camera and that additional diagnostic tests were needed. The contact was informed that the recall repair had been completed and that the repair would be at the owner's expense. The vehicle was not repaired. The manufacturer was informed of the failure and referred the contact to another dealer for assistance. The failure mileage was approximately 71,000.","products":[{"type":"Vehicle","productYear":"2017","productMake":"FORD","productModel":"MUSTANG","manufacturer":"Ford Motor Company"}]}]}