{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11734218,"manufacturer":"Chrysler (FCA US, LLC)","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"04/28/2026","dateComplaintFiled":"04/28/2026","vin":"3C6UR5ML1MG","components":"POWER TRAIN","summary":"The 68RFE automatic transmission in this 2021 Ram 2500 6.7L Cummins fails to engage reverse when the transmission reaches operating temperature. When the gear selector is placed in reverse and the accelerator is applied, the engine revs but the truck does not move. The defect is intermittent and temperature-dependent, which means it cannot be predicted or avoided by the driver. The vehicle is used to tow an enclosed cargo trailer weighing approximately 7,000 pounds.The safety risk: inability to engage reverse on demand creates a hazard in any situation requiring reverse motion, including backing away from a stopped vehicle, reversing out of a fuel station, backing a loaded trailer at a campground or boat ramp, or executing an evasive reverse maneuver. With a trailer attached, loss of reverse function can leave the truck and trailer stranded in active traffic lanes or at intersections.The defect was first reported to a dealer in August 2023 with diagnostic trouble code P2701 stored (Friction Element B implausible pressure, internal transmission fault). The code was logged but not addressed at that visit. Over the following 32 months the same defect was reported to the same dealer four additional times. On the fourth visit the dealer replaced the complete transmission and torque converter under warranty and certified the repair complete after a documented 77 mile dealer test drive. The same defect returned approximately 4 customer miles after the truck was returned to me. The truck is currently at the dealer for the fifth repair attempt, with the dealer's own write-up confirming that the vehicle will not move while in reverse at operating temperature.The defect has been confirmed by the dealer service department through their own diagnostic process, has been documented across five repair orders, and has resulted in a complete factory transmission and torque converter replacement that failed to resolve the issue.Warning indicators: a P2701 diagnostic trouble code was s","products":[{"type":"Vehicle","productYear":"2021","productMake":"RAM","productModel":"2500","manufacturer":"Chrysler (FCA US, LLC)"}]}]}