{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11745414,"manufacturer":"General Motors, LLC","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"06/12/2026","dateComplaintFiled":"06/20/2026","vin":"1GKS2JKL6RR","components":"ENGINE","summary":"I perform all maintenance on my vehicles, I have previously been a ASE Certified Master Technician, so I know engines and vehicles very well. Vehicle is outside of current engine recall window due to the engine build date being July 15, 2024. Engine was over maintained, oil and oil filter changed 6 times in 17,732 miles, first oil and filter change performed at 544 miles, when 5W30 oil was put in engine, installed a magnetic drain plug and installed Filter Mags on oil filter. Ran 5W30 oil for 2 oil changes, then moved to 0W40 oil. Oil analysis performed for each oil change. Results were looking acceptable up until the next to last oil change at 13,801 miles. Changed engine oil and filter on 6/12/2026 @17,732 miles. Found a heavy build up of metal particles on the magnetic drain plug and when oil filter was cut open there was a heavy build up of metal particles where the Filter Mags were located and the filter element had fine metal particles in entire engine oil filter element. The engine has made no noise and is still running, but based on the evidence the engine is currently failing and if I would have continued to drive it, the engine would likely lock up on the highway. CLEARLY GM DID NOT solve the crankshaft problem July 1, 2024 and CLEARLY using a higher viscosity oil like 0W40 will not keep these engines from failing. If I would have continued to drive the vehicle and if I would have not changed oil and found metal in the oil, this engine would have absolutely failed on the highway. This vehicle has over 80% highway use.","products":[{"type":"Vehicle","productYear":"2024","productMake":"GMC","productModel":"YUKON XL","manufacturer":"General Motors, LLC"}]}]}