{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11761929,"manufacturer":"General Motors, LLC","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"08/14/2026","dateComplaintFiled":"09/03/2026","vin":"1gnevgks1rj","components":"ELECTRICAL SYSTEM,UNKNOWN OR OTHER,SERVICE BRAKES","summary":"The Defective Software Trigger: vehicle\u2019s dashboard Brake Pad Life Monitor indicated the pads were low showing 19% roughly 3.5-4mm remaning life. Upon arrival to the dealership, I was informed that my rotors would also need to be resurfaced. I contested a mandatory rotor resurfacing policy. I openly disagreed with this arbitrary \"store policy\" but was forced to comply to get my vehicle serviced. The dealership stated they would refuse to replace the pads unless I paid out-of-pocket for an unnecessary resurfacing. The technician measured my pads at 7mm (over 60% of usable life remaining). My vehicle did not need brakes; it was suffering from a known factory software bug detailed in GM Bulletin 25-NA-029. Rather than identifying this warranty glitch, I was forced to pay for unnecessary vehicle repairs. The technician machined my front rotors and installed new pads. On my way home, the vehicle exhibited severe, violent steering wheel shaking under braking at highway speeds. The technician completely failed to check for runout or machine the rotors evenly. I was forced to drive 90 miles home with a violently vibrating steering system. I called the dealership but the facility was closed. To correct a severe safety hazard caused entirely by the shop, I had to drive an additional 90 miles back to the dealership (a 180-mile total round trip) on compromised brakes. I requested that the dealership replace the ruined rotors and pads at their expense. Management refused instead, to force the shaking to stop and avoid paying for hardware, the dealership refunded the original resurfacing fee (Driver side rotor 29.89mm to 1st resurface 29.20m- Passenger side 29.80mm to 1st resurface 29.25mm) and machined my front J61 rotors a Second time, cutting them down to 27.80mm Driver side and 27.59 mm on my passenger side. I have contacted corporate but I've had no resolution.","products":[{"type":"Vehicle","productYear":"2024","productMake":"CHEVROLET","productModel":"TRAVERSE","manufacturer":"General Motors, LLC"}]}]}