{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11763208,"manufacturer":"Tesla, Inc.","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"09/05/2026","dateComplaintFiled":"09/09/2026","vin":"5YJSA1E6XPF","components":"SUSPENSION,WHEELS,SERVICE BRAKES","summary":"Catastrophic structural failure of the rear driver-side (LH) brake caliper assembly on a 2023 Tesla Model S Plaid at approximately 18,036 miles. While driving normally on a public roadway, the factory-installed rear LH brake caliper bolts backed out completely due to improper assembly torque or a latent material defect.   The unbolted caliper detached entirely from its mounting bracket and collapsed into the spinning wheel barrel. The caliper became violently wedged between the wheel rim and the rotor, instantly puncturing the wheel, flattening the driver-side rear tire, damaging the passenger-side (RH) rear tire, and causing an immediate loss of vehicle control.   The loose caliper acted as an unconstrained projectile inside the wheel assembly, severing the hydraulic brake line, shredding the electronic parking brake harness, destroying the suspension links (rear lower fore/aft links), and destroying the ABS sensor/module. This failure created an extreme, life-threatening hazard of a sudden high-speed wheel lockup and total brake system failure.  An independent Pre-Purchase Inspection (PPI) was completed just 263 miles prior to this incident. The certified inspector completed an 85-mile test drive and verified the braking and suspension systems were operating in normal factory condition with zero abnormal vibrations or loose hardware. This establishes the failure as a sudden, latent assembly torque failure of factory hardware during normal operational stress.   The manufacturer's authorized service center confirmed via technician notes that the caliper came entirely loose and lodged into the wheel. Despite this being a severe assembly workmanship failure within the active factory warranty window, the manufacturer is refusing to cover the repair, alleging third-party tampering without physical or forensic proof. The failed hardware is being retained for forensic inspection.","products":[{"type":"Vehicle","productYear":"2023","productMake":"TESLA","productModel":"MODEL S","manufacturer":"Tesla, Inc."}]}]}