{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11767612,"manufacturer":"Hyundai Motor America","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"08/04/2026","dateComplaintFiled":"09/28/2026","vin":"KMHFC46F97A","components":"ELECTRICAL SYSTEM,SERVICE BRAKES","summary":"My 2007 Hyundai Azera is subject to NHTSA Recall 18V026 (Hyundai Safety Recall Campaign 172) for water intrusion into the ABS control module causing electrical short circuits and fire risk. The recall remedy — installation of a relay to cut power to the ABS module when the ignition is off — was completed on my vehicle.  Despite the completed remedy, the ABS module shorted and failed. At the diagnosing dealer (Hyundai of Ogden, Ogden, UT), technicians found a blown 20A ABS fuse and no communication with the module; when a replacement fuse was installed, the ABS module immediately began smoking. The technician documented water intrusion into the module as the cause — the same failure mode the recall addressed — and noted no outside cause. This occurred with the vehicle powered, a condition the relay remedy does not mitigate.  Hyundai Motor America initially approved a 100% goodwill replacement of the module (dealer estimate $5,531.29) but later declined because the part is discontinued and cannot be sourced. The vehicle currently has no functioning ABS.  I am filing because the recall remedy did not prevent the recalled defect from recurring: the water intrusion and short-circuit failure occurred on a vehicle that received the remedy. The relay only addresses key-off fire risk; it does not prevent module failure or the associated risk while the vehicle is powered. No injuries occurred.","products":[{"type":"Vehicle","productYear":"2007","productMake":"HYUNDAI","productModel":"AZERA","manufacturer":"Hyundai Motor America"}]}]}