{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11767940,"manufacturer":"Hyundai Motor America","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"09/10/2026","dateComplaintFiled":"09/30/2026","vin":"KMHDC86EX9U","components":"UNKNOWN OR OTHER,SERVICE BRAKES","summary":"The Anti-Lock Braking System (ABS) module has failed due to moisture intrusion that caused an internal electrical short circuit, destroying the ABS Primary Pressure Sensor.  A few days after the vehicle was parked outside during heavy rain, I was driving on a busy highway when it suddenly lost engine power. During this emergency, I had to perform heavy braking and maneuver to the shoulder without engine assist. At the same time, the ABS and Electronic Stability Control (ESC) systems suddenly disabled completely.  This failure is consistent with the safety defect described in NHTSA Campaign 20V-061 (Recall 188), which acknowledges that these ABS modules can permit moisture intrusion. However, Hyundai's remedy, installing a fuse relay, only cuts battery power while the vehicle is parked to reduce fire risk; it does not seal or repair the ABS module. Moisture from the heavy rain entered the module while the vehicle was parked and ultimately shorted the internal pressure sensor while driving, disabling critical braking and stability systems.  Two independent third-party sources (an ASE-certified mechanic and a commercial automotive diagnostic scanner) identified codes C1237 (ABS Primary Pressure Sensor Signal), C1513, and C1260. Both confirmed an internal electrical failure of the ABS module.  At Hyundai Corporate Consumer Affairs’ direction, the vehicle was inspected by an authorized Hyundai dealership. The dealership did not perform the required dynamic road test needed to reproduce the active ABS faults, and claimed there was only C1260 and not an ABS malfunction. The invoice documents identical mileage in and out, and video shows diagnostics performed while the vehicle was stationary with the engine off. Approximately 15 minutes later, an independent scanner successfully retrieved C1237, C1513, and C1260.  Despite this evidence, Hyundai Consumer Affairs refused to repair the failed ABS module, characterizing it as a “maintenance item.”","products":[{"type":"Vehicle","productYear":"2009","productMake":"HYUNDAI","productModel":"ELANTRA","manufacturer":"Hyundai Motor America"}]}]}