{"count":1,"message":"Results returned successfully","results":[{"odiNumber":11769189,"manufacturer":"Hyundai Motor America","crash":false,"fire":false,"numberOfInjuries":0,"numberOfDeaths":0,"dateOfIncident":"10/05/2026","dateComplaintFiled":"10/05/2026","vin":"5NPEC4AC4EH","components":"ENGINE","summary":"I was driving on the freeway about 100 miles outside of Boise, ID when the vehicle went into limp mode and a flashing check engine light came on. I had it towed to the Hyundai dealership in Boise where they ran a diagnostic check and it came back with a P1326 code, which is the issue related to the engine/ball bearings. They said it passed the bearing clearance test (BCT) so they updated the software and gave the car back. I picked it up a week later and while driving it from Boise to Salt Lake City (where I live), it went into limp mode again with a flashing check engine light. This happened about 100 miles north of Salt Lake City. I had it towed to a dealership in Murray. They indicated it passed the BCT again, but they replaced the knock sensor and did an oil change and gave the car back. I picked it up, and the next day, while on the freeway, the same thing happened again. I took it back to the dealership. They indicated the knock sensors they just installed the day before needed to be updated, so they updated the software for the knock sensors. I just picked it up, and within 45 seconds of being on the freeway, it went right back into limp mode with the flashing check engine light. This has happened 4 times now, on the freeway forcing me to immediately get over, and I have almost gotten into two separate accidents because of this. Hyundai says they will not replace the engine because it keeps passing the BCT. The vehicle is not safe to drive and it is likely causing irreparable damage to the other systems of the car.","products":[{"type":"Vehicle","productYear":"2014","productMake":"HYUNDAI","productModel":"SONATA","manufacturer":"Hyundai Motor America"}]}]}